Note: The MAC addresses of the HA1 interfaces, which are on the control plane and synchronize the configuration of the devices are unique. In the above output example, HA Group ID = 0b Hex (11 Decimal) and Interface ID = 14 Hex (20 Decimal). The following CLI command displays VMAC for Active-Passive HA cluster:Įthernet1/5 20 1000/full/up 00:1b:17:00: 0b: 14 Total interfaces with virtual address configured: 2 The following CLI command displays VMAC and VIP for Active-Active HA cluster: The format of the virtual MAC is 00-1B-17:00: xx: yy where On the 元 interfaces, the MAC address listed for an interface using the command show interface all for an HA cluster are the VMAC. Resolution AIS 4.0.0 will explicitly set a 300 seconds aging time as part of the intent. This means that mac-address learning is permanent and doesn't expire. (AOS-23726) If left unset on SONiC, the default mac-address aging timer will default to infinity. Management IP Address: 10.30.14.7 netmask: 255.255.255.0 Default mac-address aging timer defaults to infinity on SONiC. show ethernet-switching table or show bridge mac-table (it depends of the platform you are using). Below is an example of an SRX in switching mode that does have a MAC table. show arp shows how IP addresses are mapped with MAC addresses.
You will have an ARP table that performs MAC<->IP mapping.If your srx is not configured for ethernet switching you will not have a MAC table. The following command displays the MAC addresses of an HA cluster: RE: Checking mac table of a Juniper router. show ethernet-switching table Ethernet-switching table: 4 entries, 3 learned VLAN MAC address Type Age Interfaces default Flood - All-members default. Runtime link speed/duplex/state: 1000/full/upĬonfigured link speed/duplex/state: auto/auto/up To display an individual interface indicate the specific interface in the following command:
#Juniper show mac address table how to#
This document describes how to display interface MAC addresses.